hi there, i hope that someone could help me out: it's a few weeks that i've noticed that my Sentry MBA (ver. 1.4.1), on my Win 7 system, has stopped to automatically send the hits to the software history. also, when i click on my hits and choose "Send Result To History" it says "Access violation at address 00701C55 in module 'Sentry_MBA.exe'. Read of address 0000002C." I've not changed anything in my settings in last days, so i can't understand what happened...how can i solve this issue???

hi there fellas...so, appear I am not that good with configs but, i'm trying to learn step-by-step.

now...i got a pless config for a popup site (not made by me), which's got the "Request Method" set on "GET".

What i would like is to add a capture, but i need (to do that), to change the req. meth. on "MW"...by doing this, i will need to set all the MASTER Wizard settings?

Is here any pious soul who can easly explain me how to do that?
(i think i will need to capture the info from a redirect page, but i think i just need to enable the "Form Redirect Stage" and insert the "Redirect URL"...right??? :S

Hi there fellas...i am about to buy a cheap 3D printer on amazon, just to see if this thing is good for my job or not.
the description just says it is capable to print PLA and ABS...my question is:

can I buy ANY filament from any seller (the important thing is that it is PLA or ABS), or should i check some other parameters before???

and, if so, WHICH parameters???

thank you for any suggestions!!!

Hi everyone, i've got a weird question:

i'm trying to run an OCR config in Sentry MBA ver. 1.5.0 on Win7 x86 o.s.
The problem is that appears, when analyzing the OCR, the message shown in the title:

"Language cp5 not installed or corrupted" where cp5 i assume is the language to be installed...

is there any solution?

Thank you for any suggestion!